Galvanic Wand is a skin rejuvenation treatment which uses gentle microcurrents to infuse collagen and retinol into the deeper layers of the skin, for an intense wrinkle reduction galvanic treatment.
HOW THE GALVANIC WAND WORKS:
Galvanic Wand skin rejuvenation incorporates two facial treatments – a Cleansing Pre-Treatment to remove impurities from the skin, and an Infusion Treatment which pumps active ingredients from the collagen and retinol patches into the surface of the skin using iontophoresis.
This enhances the effectiveness of the active ingredients resulting in rejuvenated skin tone.
This technology has been available in expensive salons for many years and now this powerful facial treatment is available to use as a convenient anti-ageing treatment at home.
An anti ageing treatment that reduces fine lines and wrinkles.
Rejuvenates skin tone.
HOW TO USE:
Cleansing Pre-Treatment: The Vitamin Cleansing Gel is infused with Vitamin E to help repair and rejuvenate the skin. With the micro-current set to (-) negative the roller helps drag impurities from the skin. The gel helps replenish moisture and helps soothe the skin. We recommend the Vitamin Cleansing Gel is used once in 24 hours. If you have sensitive skin we would recommend leaving 48 hours between treatments.
Step 1: Onto clean skin apply a generous amount of Vitamin Cleansing Gel to your face. Note: Without the gel the treatment may feel prickly.
Step 2: Push the power button to ON. Set the micro-current button to (-) negative and adjust the intensity wheel to level 1.
Step 3: Move the roller slowly back and forthover the treatment area. Note: It is important that you hold the unitby the conductive panels. Correct operation is indicated by a red light when the roller contacts the skin/ gel. The unit will not make a noise or vibrate. If insufficient gel is used the treatment may feel prickly.
Step 4: To increase the intensity turn the intensity wheel clockwise to a comfortable level. Facial cleansing takes approximately 3-6 minutes.
Step 5: Thoroughly clean and dry skin. You can continue directly onto infusion treatment.
Infusion Treatment: Our gel patches contain positively charged Collagen and Retinol as anti-wrinkle and anti-ageing agents. When placing the roller set to (+) micro currents on the patches these active ingredients are directly ‘pulled’ into the skin. We recommend Collagen and Retinol patches are only used once in 24 hours. If you have sensitive skin we would recommend leaving 48 hours between treatments. The patches are profiled to fit under the eye, across the forehead, around the mouth and across the chin.
Step 1: Tear along the perforated edge of the Collagen and Retinol patch sachet. Take a patch from the plastic casing and peel off the liners to reveal the gel patch.
Step 2: Place one patch onto the area to be treated. Place the other patch on the opposite side of the face.
Step 3: Push the power button to ON. Set the micro-current button to (+) positive and adjust the intensity wheel to level 1.
Step 4: Slowly and gently move the roller back and forth along the patch. Repeat the process across the other patch. Continue treatment by alternating between patches for 10-30 minutes (5-15 minutes on each patch). Note: It is important that you hold the unit by the conductive panels. Correct operation is indicated by a blue light when the roller contacts the patch. The unit will not make a noise or vibrate. Most people will not feel anything.
Step 5: To increase the intensity turn the intensity wheel clockwise to a comfortable level.
Step 6: The patches may remain on for up to 60 minutes to continue gently infusing. After removing patches, massage any residue into your skin.
Galvanic Treatment Wand.
2x AAA Batteries.
Vitamin E Aquous Gel.
5x Collagen and Retinol Patches (2 per pack).
White Carry Pouch.
There are no reviews yet.